dji GOGGLES N3 - Maintenance; Replacing the Foam Padding; Cleaning and Maintenance

To Next Page

To Previous Page

6 Maintenance

6.1 Replacing the Foam Padding

1. Hold the position as shown below and remove the foam padding gently.

2. Align the positioning columns of the new foam padding with the positioning holes

on the goggles. Install it and press along the contour. After hearing a clicking sound,

check and make sure that there is no gap between the foam padding and the goggles.

6.2 Cleaning and Maintenance

Clean the surface of the goggles with a soft, dry, clean cloth. Use the lens cleaning cloth to

clean the lenses in a circular motion from the center to the outer edges.

• DO NOT clean the integrated goggle lenses with alcohol wipes.

• Clean the lenses gently. DO NOT scratch them as this will aect viewing quality.

DJI Goggles N3 User Manual