dji INSPIRE 3 - Frame Arm Leds; Battery Compartment; Data Ports

DJI Inspire 3 Maintenance Manual
©
2023 DJI All Rights Reserved.
11
Frame Arm LEDs
• Make sure that the frame arms are not damaged and that there is no foreign matter on the
frame arm surface.
Battery Compartment
• The battery ports are clean and dry without any corrosion. Clean any unwanted dust or
water inside the battery compartment.
• The battery ports are not damaged and the metal terminals are not deformed.
• The screws on the battery release toggles are securely tightened.
• The battery release toggles is working properly after being pressed.
• After the battery is installed, make sure that the battery release toggle is working properly.
Data Ports
1. Clean any unwanted residue near the ports with a gauze.
2. If the ports are in use, disconnect the cables and check for any unwanted residue in the
ports with the help of a torch.
3. Use tweezers to remove any foreign matter in the port, such as small stones and pieces of paper.
4. Remove any unwanted residue inside the port with a gauze.
5. Place the aircraft on its side and use a gauze or brush to remove any unwanted foreign
matter, such as dust from the port. Note, clean the port thoroughly making sure to sweep
away from the port.