DJI Inspire 3
Maintenance Manual
©
2023 DJI All Rights Reserved.
17
Standard Charge and Discharge Operation Instructions
1. Fully charge the battery and let the battery rest for at least 24 hours.
2. Install the battery into the aircraft before ight. If the remaining power level is less than 20%,
land the aircraft and remove the battery.
3. Let the battery rest for at least one hour.
4. Fully charge the battery or charge it to the proper power level for storage after completing
battery maintenance.
Battery Replacement Standard
• The battery is visibly swollen*, leaky, or damaged.
• The battery is rated for 200 cycles. It is not recommended to continue using the battery after
200 cycles.
• The battery error still exists after performing the standard charge and discharge operations
twice continuously.
* The TB51 battery shell is made of soft material and may bulge slightly. The battery can be used if it can be
successfully inserted into the aircraft properly.
Battery Disposal
1. Fully immerse the battery in an insulated bucket with 5% salt solution. Leave the battery in
the solution for more than 48 hours to fully discharge the battery.
2. It is recommended to recycle the battery by following the instructions in the User Manual to
avoid environmental pollution.
Battery Usage Notes
• DO NOT charge the battery near ammable materials or objects or on ammable surfaces.
• DO NOT use the battery in a humid environment to avoid short circuit.
• Never disassemble or pierce the battery in any way.
• Store the battery in a well-ventilated and dry place.
• Initiate RTH immediately when the app prompts that the battery temperature is too high.
Charge to 100% Rest for 1 hour Discharge to below 20% Rest for 1 hour