dji MATRICE 300 RTK - Page 78

78
©
2020 DJI All Rights Reserved.
MATRICE 300 RTK User Manual
Tracking target (in gimbal follow mode)
In gimbal follow mode, the orientation of the aircraft is always consistent with that of the gimbal, both
aiming at the target. The attitude of the gimbal will be adjusted automatically to situate the target in the
center, while the camera will adjust its zoom to re-size the target. The user can ne-tune the size of the
target in the eld of view using the right dial of the remote controller.
Target Prediction: If a target is lost, the device will predict the motion trajectory and the gimbal will rotate
automatically to search for the target.
Target Search: If the target is lost, the device will automatically search for its based on its predicted
position. The user can also manually control the gimbal rotation and camera zoom to nd the target.
Target positioning: The GNSS position of the target will be displayed in the navigation display and map
(note that when the laser rangender of the H20N or the H20 series gimbal and camera continues to
be invalid, the target position is for reference only), the position of the target will also be displayed in the
FPV view.
Focus Tracking: The camera focus will be adjusted according to the distance of the target object.
In gimbal follow mode, “Smart Track” will be displayed on the top bar during tracking. The control mode
of the aircraft is slightly dierent from its normal ight mode. Make sure you are familiar with the following
controls and y with caution.
Remote controller
operation
Aircraft performed Important
Pressing and holding
the Pause button
Exits Smart Track. /
Yaw stick
Adjusts yaw movement of
gimbal
The adjustable range is limited during
tracking.
Pitch stick
Flies the aircraft toward or away
from the target horizontally.
The maximum ight speed is
less than 17 m/s. Continue
operating the stick to keep
tracking the target.
When it is close to the target horizontally,
the aircraft’s speed in the direction
close to the target will be limited. The
aircraft cannot approach the target in the
following condition:
a. The aircraft is less than 5 meters from
the target.
b. The target is under the aircraft that the
gimbal tilt needs to be greater than 80°.
Roll stick
The aircraft circles the target
horizontally. The maximum
ight speed is less than 17 m/s.
When it is close to the target horizontally,
the aircraft’s orbiting speed will be limited.
Throttle stick
Controls the aircraft altitude /
Gimbal pitch control dial
Adjusts the gimbal tilt The adjustable range is limited during
tracking.
Gimbal pan control dial
Adjusts the camera zoom The adjustable range is limited during
tracking.