dji MATRICE 300 RTK - Page 88

88
©
2020 DJI All Rights Reserved.
MATRICE 300 RTK User Manual
AI Spot-check can only be used with the H20 series payload in zoom camera view.
AI Spot-check takes photos at up to 10 times the focal length.
RTK should be used for photo capture and Planned Route ight of the AI Spot-check, and the
RTK base station coordinates of the photo capture and Planned Route ight must be the same.
AI Spot-check can support up to 750 photos.
The ratio of the selection box size of the photo to the area of the whole photo cannot be less
than 1/25 when using AI Spot-check.
The selection box position must be in the middle of the view and the size needs to be the
same as the target size.
If Advanced Dual Operator Mode is in use, Controller A must be used to complete the Demo
Flight and mission upload.
H20 and H20T gimbal and camera should be installed on the 1st gimbal port.
a
b
f
d
e
c