dji Matrice 600 Pro

©
2017 DJI All Rights Reserved.
15
MATRICE 600 PRO User Manual
[10] Camera Settings Dial
Turn the dial to adjust camera settings.
Only functions when the remote controller is
connected to a mobile device running the
DJI GO app.
[11] Playback Button
Playback the captured images or videos.
[12] Shutter Button
Press to take a photo. If in burst mode, the
set number of photos will be taken with
one press.
[13] Flight Mode Switch
Used to switch between P, A and F mode.
[14] Video Recording Button
Press to start recording video. Press again
to stop recording.
[15] Gimbal Dial
Use this dial to control the tilt or pan of the
gimbal.
[16] Micro USB Port
Reserved.
[17] SDI Port
Connect an SDI display device.
[18] HDMI
TM
OUT Port
Connect an HD compatible monitor.
[19] USB Port
Connect to mobile device to access all of
the DJI GO app controls and features.
[20] GPS Module
Used to pinpoint the location of the remote
controller.
[21] Back Left Button
Customizable button in the DJI GO app.
[22] Back Right Button
Customizable button in the DJI GO app.
[23] Power Port
Connect to a power source to charge the
remote controller’s internal battery.
[13]
[15]
[10]
[11]
[12]
[14]
[16] [18]
[17] [19]
[20]
[21]
[23]
[22]
[5] Landing Gear Control Switch
Toggle the switch up or down to raise or
lower the landing gear.
[6] Battery Level LEDs
Displays the current battery level.
[7] Status LED
Displays the power status.
[8] Power Button
Used to power on or power off the remote
controller.
[9] RTH Status LED
Circular LED around the RTH button displays
RTH status.