dji Matrice 600 Pro

52
©
2017 DJI All Rights Reserved.
MATRICE 600 PRO User Manual
Flight Controller
[1] IMU1
Communicates with the IMU Pro module. Connected before delivery.
[2] CAN1
Dedicated DJI CAN-Bus port. Communicates with the GPS-Compass Pro module or other DJI
devices (e.g. Real Time Kinematic (RTK) GPS system, gimbals).
[3] Orientation Arrow
Points to the front of the aircraft.
[4] Status Indicator
Indicates the status of the ight controller and triple modular redundancy system.
[5] RF Port
Communicates with the DJI Lightbridge 2 Air System. Connected to the Lightbridge 2 Air System
upon delivery.
[6] iESC Port
Communicates with the DJI Smart ESC. Connected to the DJI Smart ESC upon delivery.
[7] M1-M8 Pins
Connects to the corresponding ESC PWM port for each motor. M1-M6 have been connected to
the ESCs and M7 has been connected to the ground upon delivery. M8 is reserved.
[8] LED Port
Communicates with the LED module. Connected to the Aircraft Status Indicator upon delivery.
[9] IMU2 Port
Communicates with the IMU Pro module. Connected before delivery.
[10] PMU Port
Derives power from the PMU. Connected to the PMU upon delivery.
[11] CAN2
Communicates with an SDK device.
[12] API Port
Communicates with an SDK device.
[13] F5-F8 Pins
Multifunction PWM output ports.
[14] F1-F4 Pins
Multifunction PWM output ports. The fan control cable (1-pin) has been connected to the F1 pin
and the landing gear servo cable has been connected to the F2 pin upon delivery.
[15] S-Bus Port
The fan power cable (2-pin) has been connected to the S-Bus port upon delivery.
[9]
[10]
[11]
[12]
[13]
[14]
[15]
[1]
[3]
[5]
[2]
[4]
[6]
[7]
[8]
A3 Pro Flight Control System Overview