EasyManuals Logo

dji Naza-M V2 User Manual

dji Naza-M V2
29 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
©2013 DJI Innovations. All Rights Reserved.
FLYING NOTES(VERY IMPORTANT)!!!
(1) If the warm up waiting is longer than 2 minutes (the 4 times Yellow blink continues), please power
off for 10 minutes, cold start, and then connect the assistant software, enter the "Tools" - > IMU
calibration, carry out the Advanced calibration.
(2) If you enable the Immediately Mode of Motor Stop; you should not pull throttle stick under 10%
during flight, because it will stop motors. If you do it accidentally, you should push the throttle
stick over 10% in 5s to re-start motors.
(3) DO NOT execute the CSC during normal flight without any reason, or it will stop motors at once.
(4) Pay attention to the GPS satellite status LED indicator. Bad GPS signal may lead the aircraft to
drift when hovering.
(5) DO NOT fly near to ferromagnetic substances, to avoid strong magnetic interference with the
GPS.
(6) Please avoid using GPS ATTI. Mode in the areas, where GPS signal is most likely bad.
(7) If the LED flashes quickly Red then this indicates battery voltage is low, land ASAP.
(8) If the transmitter indicates low-battery alarm, please land ASAP. In this condition the transmitter
may cause the aircraft to go out of control or even crash.
(9) In GPS ATTI. Mode, make sure that the home point is recorded when the GPS signal is well;
otherwise the home point recording may be not so precise.
(1) In ATTI Mode, throttle stick center position is for 0m/s along the vertical direction. You should
keep the position of throttle stick higher than 10% from cut-throttle during the flight! In any
control mode, DO NOT pull throttle stick under 10% during normal flight without any reason.
(2) It is recommended to land the aircraft slowly, to prevent the aircraft from damage when landing.
(3) If Low-Voltage Alarm is set, the aircraft will act according to the configuration of the Assistant
Software once Low-Voltage Alarm is triggered. Make sure you remember what you have set
before.
(4) If Fail-Safe function is set, the aircraft will act according to the configuration of the Assistant
Software once Fail-Safe is triggered. Make sure you remember what you have set before.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the dji Naza-M V2 and is the answer not in the manual?

dji Naza-M V2 Specifications

General IconGeneral
Working Voltage4.8V - 5.5V
Operating Temperature-10°C to 50°C
Firmware UpdateSupported
Max Supported Motors8
Communication InterfaceUSB
Firmware UpgradeableYes
Built-in FunctionsIntelligent Orientation Control (IOC)
Assistant SoftwareDJI NAZA Assistant Software
Supported ESC Output400Hz
Recommended TransmitterPCM or 2.4GHz with minimum 4 channels
Power Consumption (Typical)0.4W
GPS CompatibilityYes
Flight ModesManual Mode, Atti. Mode, GPS Atti. Mode

Related product manuals