DJI Osmo Action 3
User Manual
©
2022 DJI All Rights Reserved.
5
Accessories
Osmo Action 3 is compatible with various accessories to flexibly change the position to
shoot various sports scenes.
Osmo Action 3 Adhesive Base Kit
The Osmo Action 3 Adhesive Base Kit includes the following accessories.
Accessory Description
Osmo Action 3 Quick-Release Adapter Mount: With a
magnetic design, the quick-release adapter mount can be
easily attached to the camera and connected to the other
accessories.
Osmo Locking Screw: Secures the Osmo Action 3 Quick-
Release Adapter Mount to the Osmo Flat Adhesive Base.
Osmo Flat Adhesive Base: The base forms a strong, durable,
and long-lasting bond on clean and flat surfaces, ensuring
secure mounting.
Press down on the camera until the clips of the quick-release adapter mount are firmly
inserted into the quick-release slots on the camera, and then tighten the locking screws.
Wipe the surface of the object before attaching the adhesive base. Attach and press the
adhesive base down firmly, and hold for at least 10 seconds. It is recommended to wait 30
minutes before attaching the camera.
• Make sure that the clips of the quick-release adapter mount are firmly inserted into
the quick-release slots on the camera before use. Press both clips of the quick-release
adapter mount when removing the camera.
• DO NOT attach the adhesive base to surfaces that are arched, curved, rough,
powdered, peeling, covered in dust or sand, or have oil, wax, or water stains.
Otherwise, the adapter mount may not be attached firmly.
• The recommended application temperature for the base is -10° to 40° C (14° to 104° F).
DO NOT attach the adhesive base to a surface with a higher or lower temperature.