DJI Osmo Action 3
User Manual
©
2022 DJI All Rights Reserved.
7
opening the battery case. The status LEDs will display the battery level. When a charger
is connected to the battery case with batteries inserted, the battery case will charge the
batteries. When the batteries are inserted into the battery case, with external devices
connected to the USB-C port, the batteries can be used as a power bank to charge the
connected external devices.
The batteries with the highest power level will be charged first, followed by the remaining
batteries to be charged in sequence. The batteries with the lowest power level will be
discharged first, followed by the remaining batteries to be discharged in sequence.
When using the battery case to charge the Osmo Action 3 Extreme Battery, it is
recommended to use the DJI 30 W USB-C Charger (not included as standard) or a USB-C
charger that supports Power Delivery or PPS (Programmable Power Delivery). Three
batteries can be fully charged in about two hours with the DJI 30 W USB-C Charger.
• DO NOT use the battery case to charge a non-DJI OSMO battery. DJI OSMO shall not be
responsible for any fault or damage caused by the use of any non-DJI OSMO battery.
• Place the battery case on a flat and stable surface when in use. Ensure the device is
properly insulated to prevent fire hazards.
• DO NOT attempt to touch the metal terminals on the battery case.
• Clean the metal terminals on the battery case with a clean, dry cloth if there is any
noticeable buildup.
• The battery case is not waterproof. DO NOT place it in water or spill any liquid on the
case.