To Next Page

To Previous Page

Osmo Mobile 6 User Manual

a. Drag a box on the screen in the camera view in DJI Mimo. A green box around the

subject indicates ActiveTrack 5.0 is successfully enabled. Tap the icon on the top

corner to stop tracking.

b. Enable Gesture Control

OFF

,select “Follow and Shoot” in DJI Mimo, and perform a

palm or V gesture for one to two seconds when facing the camera. The gimbal will

follow the subject closest to the camera. The detection range between the rear

camera and the gesture is 0.5 to 4 m. Note that ActiveTrack 5.0 may consume

more power and cause the temperature of the mobile phone to increase. Perform

a palm or V gesture to stop recording.

c. Press the trigger once to start or stop ActiveTrack 5.0. The gimbal will follow the

subject in the center of the screen by default. When using ActiveTrack 5.0 move the

joystick to adjust the camera view.

4. Gimbal Battery Level

: Displays the current battery level of the gimbal.

5. Mobile Phone Battery Level

: Displays the current battery level of the mobile phone.

6. Flash

: Displays the flash status.

7. Gimbal Mode

: Displays the current gimbal mode: Follow, Tilt Locked, FPV, or SpinShot.

8. Focus/Zoom Mode

: Indicates the feature of the side wheel when using focus (MF) or zoom (ZM).

9. Front/Rear camera Switch

: Tap to switch between the front and rear cameras of your mobile phone. Selfie,

Follow, and glamour effects are automatically enabled when switching to the front

camera. Note: glamour effects are not supported when recording at 4K or 60fps.

10. Shooting Modes

Scroll to select the shooting mode.

Hyperlapse: enable to shoot a Timelapse photo while moving the mobile phone. Tap

the shutter button to begin.

Timelapse: there are four types of timelapse (Fixed Angle, L to R, R to L, and Custom

Motion). After selecting the timelapse, tap the settings at the top of the screen. For

Other manuals for dji OSMO MOBILE 6

Questions and Answers:

Need help?

Do you have a question about the dji OSMO MOBILE 6 and is the answer not in the manual?

General