To Next Page

To Previous Page

Firmware Update

Use DJI Mimo to update the Osmo Mobile 6 firmware. It takes approximately three

minutes to complete an update.

How to Update

Before starting an update, make sure that the battery level indicator shows green or

yellow. Connect Osmo Mobile 6 to your mobile device and launch DJI Mimo. You will be

prompted if a new firmware update is available. To start updating, connect the mobile

device to the internet and follow the on-screen instructions.

Do not exit DJI Mimo while updating the firmware. Pay attention to on-screen prompts.

The system status indicator will blink green and red alternatively and become solid green

once the firmware update has completed successfully.

If an update is unsuccessful, restart DJI Mimo, reconnect the Bluetooth, and retry.

Storage

Osmo Mobile 6 is designed to be folded for easier storage and transportation. Make

sure to fully retract the built-in extension rod and fold the Osmo Mobile 6 after powering

off. Rotate the pan and tilt axis as shown and fold the gimbal. The mark on the axis arm

should slot into the hole on the handle. Rotate the pan axis as shown to lock in place.

Other manuals for dji OSMO MOBILE 6

Questions and Answers:

Need help?

Do you have a question about the dji OSMO MOBILE 6 and is the answer not in the manual?

General