To Next Page

To Previous Page

M Button

When powered off

With the gimbal folded, press once or press and hold: check the

battery level

With the gimbal unfolded, press once: power on

When powered on

Press once: switch between gimbal modes

Press three times: enter standby mode (press any button to exit)

Press and hold: power off. Press and hold for 20 seconds to force

power off

Using Osmo Mobile 6

On-board Features

Status Panel

Displays the System Status Indicator, Battery Level Indicator, and Gimbal Mode.

System Status Indicator Descriptions

Blinking Pattern Descriptions

Pulses red Magnetic is not aligned

Solid yellow Bluetooth disconnected

Solid green Bluetooth connected

Pulses yellow or green Standby mode

Blinks red and green alternately Firmware updating/firmware update failed

Solid red Abnormal status detected

Battery Level Indicator Descriptions

Blinking Pattern Battery Level

Blinks red quickly ≤5%

Solid red 6%-19%

Solid yellow 20%-60%

Solid green >60%

Gimbal Mode

Follow: pan and tilt axes follow, where both the pan and tilt axes follow the movement

of the grip. Suitable for scenarios when moving up and down or on a slant.

Tilt Locked: only the pan axis follows, where only the pan axis follows the movement

of the grip. Suitable for scenarios such as arc shots or moving from left to right.

FPV: pan, tilt, and roll axes follow, where all three axes follow the movement of the

grip. Suitable for shooting the first-person view.

SpinShot: pan, tilt, and roll axes follow. The joystick can be used to control the roll axis

rotation. SpinShot enables footage to be shot while rotating the camera 360°. This is

suitable for shooting push, pull, and down.

Other manuals for dji OSMO MOBILE 6

Questions and Answers:

Need help?

Do you have a question about the dji OSMO MOBILE 6 and is the answer not in the manual?

General