©2013 DJI Innovations. All Rights Reserved.16 |
Failsafe Function
FailSafe works when the Transmitter (TX) signal is lost, the flight control system will automaticallycontrol the
aircraft to reduce injuries or damage.
30secs later after power on; 10secs later after ≥6( or no Red LED);
Motors have been started; auto-record the position as home point at the first time
the throttle stick is raised.
Flight control system can automatically control the aircraft after Transmitter signal
is lost. It should be set in Assistant software->Advanced->F/S, while Hover,
Go-Home or Alt Go-Home is optional.Additionally, a Go-Home switch can be
enabled.
Go Home switch can be used to trigger a go home without FailSafe. If One-Key
Go Home is enabled during flying, you no longer have controlof the aircraft, the LED
blinks in its Control Mode. If One-Key Go Home is disabled, you regain the control
at once. If already in a Failsafe condition, then the switch will not work.
Failsafe and Go Home procedures
1 Record Home Point (HP)
2 Confirm Home Point
3 Transmitter Signal Lost
5Go Home(20m can be customized)4 Signal Lost Lasts 3secs.
Height over HP<=20m
Height over HP>20m
6 Landing after Hovering 15secs
20m
Elevate to 20m
LED LED LED
LED LED LED
<8m
≥7
(∝)
(6)
(∝)
(∝) (∝)
(∝)
(1) The aircraft will not go home (only attitude stabilizing)in the condition that <6 or GPS is
not working, even if Transmitter signal is lost or Go Home switch is triggered.
(2) Itis recommended to set the Go Home switch in the Assistant software. Users are suggested to
enter Failsafe and go home by using the Go Home switch rather than turning off the Transmitter
in emergencysituations.
(3) Make sure there are no obstacles during aircraft go home and users are familiar with the
To Next Page
Loading...
