©2013 DJI Innovations. All Rights Reserved.17 |
methods to regain control.
How to regain control in FailSafe
You have to toggle the control mode switch
once to regain control if the signal recovers, y.
Regain control as soon as signal recovers.
Low voltage protection is used to alert low battery voltage during flight; in this case, users should promptly
fly back the aircraft and land to avoid unexpected damages.
Make sure the home point is recorded and
no obstacles in going home and landing
path.
Go-Home & Landing Usage Tips
(1) The home point recorded is the same in both Failsafe and Low voltage protection. The aircraft will not
go home in the following cases :
a) Control mode is in Control Mode 1 (Manual or ATTI 1)
b) GPS signal is bad( <6)
c) The distance between aircraft and the home point is less than 25m, and the height over the
Home point less than 20m.
The aircraft will not hover when the throttle stick is at the mid point. Push the throttle stick to 90% of
endpoint, the aircraft will still ascend slowly if you continue to pull the throttle stick, and the control of Pitch,
Roll and Yaw are the same as before.
Please pay attention to the LED alert of low voltage and make sure the power is enough for go home
and landing.Insufficient power reserve will cause the aircraft to crash and other consequences.
To Next Page
Loading...
