DJO VENAFLOW Elite - System Alarms; Alarm Reset; S Mode Operation

12
ENGLISH
System Alarms
Alarm Reset
To reset any alarm, press the button and take steps to correct the alarm if
necessary. Pressing the button does not x the alarm but silences it until the problem
is xed. If you wish to turn the device completely o, you must press the power button
once to silence alarm and a second time to power down the device.
S Mode Operation
When powered on, the VenaFlow Elite System will default to standard rapid ination
mode. If a slower ination is desired, select the S mode operation button. Once
selected, both cus will inate simultaneously once per minute. Both cus will inate
and compress for a total of 10 seconds. While in S mode the icon will appear in
the top center of the graphical display. The device will remain in S mode until user
presses the S mode operation button again. This button allows user to toggle between
standard rapid ination mode and S mode.
Locking the System in Standard Rapid or S Mode
You have the ability to lock the system in either standard rapid mode or S mode. Once
a mode is locked, it will stay in that mode regardless of powering the device on or o.
Once locked, it is not possible to toggle modes until the system is unlocked.
To lock the system in standard rapid ination mode: First
make sure the device is in standard rapid ination mode. The S
mode icon should NOT appear on the display. Next, press and
hold the S mode button for no less than 5 seconds. After 5
seconds, a lock will appear at the top center of the display.
This lock icon indicates that the system is locked in standard
rapid mode.
To lock in S mode: First select S mode and make sure the
S mode icon appears at the top center of the display.
Press and hold the S mode button again for no less than
5 seconds. After 5 seconds, a lock will appear next to the S
mode icon at the top center of the display. This lock icon
next to the S mode icon indicates that the system is locked in S
mode.
To unlock either mode: Press and hold the S mode button for no less than 5
seconds. After 5 seconds, the lock icon will disappear.