DJO VENAFLOW Elite - Replacement Kit Instructions; Installing;Removing;Replacing the Power Cord; Telescoping Bed Hanger Replacement; Replacing Fuses

17
ENGLISH
Replacement Kit Instructions
Replacement kits may be ordered through customer care.
Replacement Kit Instructions
Instructions for Installing/Removing/
Replacing the Power Cord
1) Make sure system is powered o and unplugged.
2) Remove the screw retaining the power cord cover
using a 1/16” hex driver.
3) Remove the power cord cover.
4) Remove the power cord.
5) Install new power cord and reassemble power cord
cover.
Telescoping Bed Hanger Replacement
1) The telescoping bed hanger piece can be removed
and replaced if necessary.
2) To replace the bed hanger, hold down release
button on the back of the system and rmly pull
bed hanger out of the body of the system.
3) Discard the broken or ineective hanger. To install
the new bed hanger, slide the new hanger back into
the body of the device and set at desired length.
Instructions for Replacing Fuses
1) Remove the power cord. Refer to the ‘Instructions for installing/removing/
replacing the power cord’ section.
2) Remove fuse holder from power entry module.
3) Remove fuses from fuse holder.
4) Replace any blown fuses with 250V, 2A, IEC fast acting
5X20mm fuses.
5) Reassemble fuse holder and replace power cord per
previous instructions.