High Speed (Refrigerated) Micro-Centrifuge
13
CAUTION:
● Any abnormality such as corrosion or scratches are found, stop using the rotor and
contact our service center.
● Only manufacturer’s rotors which claimed can be used with the unit.
Check the rotor and bucket for corrosion or scratch before using.
7.5 Symmetrically load centrifuge tubes in rotor
CAUTION:
z Make sure the rotor door is securely fixed on the rotor, rotor and shaft are tightened.
Otherwise, the rotor may be moved off while rotating and cause damage of the
centrifuge or rotor.
z Firmly tighten the rotor door with rotor.
8. Operation
8.1 Normal operation
Turn on the POWER switch, centrifuge will start the self-checking process. (See figure 8-1)
Figure 8-1 Self-checking interface
CAUTION:
● Do not push or lean against the centrifuge while it is running.
● Do not run the centrifuge, when fragment or sample solution left in the centrifugal
chamber. Always keep the centrifugal chamber clean.
● If this centrifuge makes strange noise during operation, stop it immediately and contact
our service center. Notify the alarm code if displayed.
HELLO 88 ℃ 88 min
To Next Page
Loading...