DLab SK-L330-Pro - Instrument Removal and Installation; Instrument Removal Procedure

1
Chapter 1: Working Principle
1.1 Introduction
1 2 3 4 5 6
FIG.1
Item 1 2 3 4 5 6
Function
Power
Switch
Rocker
Plate
Speed
Display
Time
Display
Speed Control
Knob
Timer Control
Knob
Shaker carries an object to conduct linear or circular motion at different speeds, and then mix
the material.
Fig. 1 is the schematic diagram of Shaker SK-O/L330-Pro. There are Speed display, Time
display, speed control knob, and timer knob on instrument control panel; power switch, on
the side of instrument; After properly connect the power cord and turn on power switch,
users set experimental conditions on the control panel by speed control knob and timer
knob, and real-time observe parameters setting values and actual values on screen.