14 LCD Keypad Installation Guide
Additional Programming
The 7063/7063A, 7073/7073A, and 7163/7173, keypads allow users to present
a proximity credential to the built-in proximity reader. Users can also manually
enter their user code into the keypad. The keypad veries the user code and its
authority with the panel. Additionally, the 7073/7073A/7173 activate the on-board
Form C relay releasing a door strike or magnetic lock. To provide added exibility,
the 7073/7073A/7173 Keypads allow connection of an external Wiegand output
compatible reader.
Programming Cards into the System
This programming feature operates on 7063/7063A/7163, and 7073/7073A/7173
keypads only. Access the User Menu in one of two ways. When MENU? NO YES
displays, choose YES and present your proximity credential to the reader or manually
enter your user code into the keypad.
From the User Menu, select USER CODES?. Choose ADD. At the ENTER CODE: - display,
present the credential to the reader. The keypad works by reading the 4 to 10-digit
user code from the data sent by the access control reader. For more information,
refer to Entry Cards in the programming section of this document and the panel
User’s Guide section on adding, deleting, and changing user codes.
Proximity Credentials Compatibility
DMP Keypads with internal proximity readers are compatible with most standard
125Khz Prox credentials available from HID and all DMP proximity credentials.
DMP Keypads are not compatible with iClass or other non-HID credentials. There
are custom and non-standard credentials from HID that are not compatible with
DMP proximity keypads. If you are using HID cards that have not been purchased
directly from DMP, it is recommended to thoroughly test the application fully before
installation. DMP does not guarantee compatibility with credentials not purchased
from DMP.
User’s Guide
This User’s Guide covers 7063/7063A, 7073/7073A, and 7163/7173 keypads and
contains three different sections: Keypad Arming and Disarming, Keypad Door Strike,
and Keypad Entry Delay. All of the examples displayed assume that CLOSING CODE is
YES in panel programming.
Note: Figures 9 through 12 show the user presenting their card to the keypad. When
an external reader is connected to a 7073/7073A/7173 keypad, the user presents
their card to the reader rather than to the keypad.
Keypad Arming and Disarming
Area system Arming and Disarming
Press COMMAND, the keypad displays ARM DISARM. Press the Select key under either
option. The keypad displays ENTER CODE: -. Present your card to the reader. Once
validated by the system, all areas assigned to your code arm or disarm automatically
and the 7073/7073A/7173 keypad Door Strike relay activates.
To Next Page
Loading...
Need help?
General
