4. Connect the POSITIVE leg of the LED to the RED
terminal on the panel
5. Connect the other leg of the LED to the second
ORANGE wire on the harness
6. Connect the second GRAY wire to the BLACK terminal
on the panel
7. Power the panel back up
8. Enter the Programmer by entering 6653 (PROG) at
the keypad
9. Navigate to ZONE INFORMATION and press a top-
row select area
10. Navigate to settings for ZONE 1
11. Program ZONE 1 as a NIGHT type zone in AREA 1
12. At the NEXT ZN? prompt, select NO
13. Navigate to DISARMED SHORT and press CMD until
OUTPUT NO is displayed
14. Press a select area to set the output to 1.
15. Set the output action to FOLLOW
16. Navigate to STOP to save changes and exit the
Programmer
17. Press the button to trip ZONE 1.
ê Notice the output state follows the zone state.
CREATE AN OUTPUT SCHEDULE
1. Enter the user menu and press CMD until
SCHEDULES? is displayed.
2. Press a select area, then select TIMES, then ADD.
3. Enter 1 for the schedule number, then name the
schedule LED.
4. Set begin and end times for each day of the week.
5. When all times are set, press the BACK ARROW until
SAVING SCHEDULES is displayed on the keypad.
6. Re-enter the schedule programming section. Press
CMD and select OUTPUT.
7. Enter output 1, then schedule 1.
8. Press the BACK ARROW to exit schedule
programming.
9. Advance panel time to test the begin and end times
for the schedule.
QUESTIONS
What else would you like to learn about the XR series?
NOTES:
XR150/550 LAB GUIDE
To Previous Page
Loading...
Need help?
General
