DNP DS?RX1 - Solving Media Errors

DSRX1Manual 
VersionNumber:1.01

20



Solving Media Errors
1. ReleasetheOpenLever,andopenthefrontcover.
2. Removetheribbon.
a. Ifthepaperisjammed:
1. Pulloutanypaperremainingintheprinter,andcutoffanywrinkledorpartiallyprinted
areasevenlywithscissors.Printingoveranareathathasalreadybeenprinted
uponwill
maketheribbonstick,andthepaperwilljamagain.
Whenpullingthepaperout,pullitslowly.Applicationoftoomuchforcecandamagethe
printer.
2. Cuttingthepaper:
Ifthepaperisnotcutevenly,itmaycauseabnormalprintingand/orthepapertojam.
Then
followthesectiononsettingthemedia(p.14).