DNP DS?RX1 - WEEE MARK; Cautions for Setup

DSRX1Manual 
VersionNumber:1.01

6



 Thethermalprintgetsveryhot.Donottouchafterprinting.
Thereisadangerofburns.

 Do nottouchthegearmechanisms.Thereisadangerofinjuryif
fingersgetcaughtinthespinninggears.

WEEEMARK
Ifyouwanttodisposeofthisproduct,donotmixwithgeneralhouseholdwaste.Thereisa
separatecollectionsystemforusedelectronicsproductsinaccordancewithlegislation
undertheWEEEDirective(Directive2002/96/EC)andiseffectiveonlywithintheEuropean
Union.
CautionsforSetup
 Priortooperation,read“ForSafeOperation”sectioncarefullyandobservetherulescontained.
 Usecarewhenmovingtheprinter.Nevertrycarryingtheprinteralone.Droppingtheprintercould
causeinjuryordamagetootherproperty.
 Donotuseorstoretheprinternearfire,excessivemoisture,
indirectsunlight,nearanairconditioner
orheater,oranyothersourceofunusuallyhighorlowtemperatureorhumidity,orexcessivedust.
 Donotplacetheprinterwherechemicalreactionsoccur,suchasinalaboratory.
 Donotsetuptheprinterwherethereissalinity
orcorrosivegasintheair.
 Theprintermustsitonafirmlevelsurfacewherethereisampleventilation.
 Donotputanythingofthetopoftheprinter.
 Donotplacetheprinterneararadioortelevision,anddonotusethesamewalloutlet
fortheprinter
andradioortelevision.Radioortelevisionreceptioncouldbeadverselyaffected.
 Donotuseapowervoltageorfrequencyotherthanthosespecified.
 Donotputanythingonthepowercordorsteponit.
 Donotdragorcarrytheprinterby
thepowercordorUSBcable.
 Avoidpluggingthepowercordintoanoutletwithmanyloads.
 Donotbundlethepowercord.
 Alwaysgriptheplughousing,notthecord,toplug/unplugthepowercord.
 Makecertainthepoweristurnedoffbeforeconnecting/disconnectingtheUSB
cable.
 Avoidlengtheningthesignalcableorconnectingittoanynoise‐producingdevice.Ifitisunavoidable,
useashieldedcableortwistedpairforeachsignal.
 Placetheprinterneartheoutletwherethepowercordcanbeunpluggedeasilytoshutoffpower.
 Use
anACoutletthatacceptsathreeprongedplug.Otherwise,theremaybedangerofelectricshock.
 Usetheappropriatespecifiedcordset.
 Onlyuseitemsthatarecertifiedsafeaccordingtothestandardsofthecountrywheretheprinteristo
beused.