DNP DP-DS80D - User Manual

Other manuals for DNP DP-DS80D

User Manual30 pages

Startup Guide33 pages

Questions and Answers

S
Steven ButlerAug 19, 2025
What to do if my DNP DP-DS80D Printer is jammed with paper?
- J
  Jacob NewmanAug 19, 2025
  If your DNP Printer is jammed with paper: * Pull the remaining paper in the direction shown and cut off any wrinkled or partially printed areas evenly with scissors. * Remove the scrap box and rewind the paper.
T
Terry HallAug 21, 2025
What to do if there is a 'POWER RIBBON PAPER ERROR - Paper end' on my DNP Printer?
- N
  nicholasfrazierAug 21, 2025
  If your DNP Printer displays a 'POWER RIBBON PAPER ERROR - Paper end', set a new roll of paper.
O
owernerAug 23, 2025
What to do if there is a 'POWER RIBBON PAPER ERROR - Ribbon end' on my DNP DP-DS80D?
- D
  Dawn NelsonAug 25, 2025
  If your DNP Printer displays a 'POWER RIBBON PAPER ERROR - Ribbon end', set a new ribbon.
D
dwalkerAug 26, 2025
What to do if the ribbon is caught in the DNP DP-DS80D?
- D
  donaldstantonAug 26, 2025
  If the ribbon is caught in the DNP Printer: * Cut the ribbon. * Remove all the ribbon remained in the printer unit. * Reattach the ribbon with tape or similar material. * Rotate the take-up roller until the part attached with tape cannot be seen anymore.
N
nicole08Aug 28, 2025
What to do if there is a 'POWER RIBBON PAPER ERROR - Door is open (no paper)' on my DNP DP-DS80D Printer?
- W
  William NelsonAug 28, 2025
  If your DNP Printer displays a 'POWER RIBBON PAPER ERROR - Door is open (no paper)', properly set the paper and then close the mechanism unit.
S
sdavisAug 30, 2025
What to do if there is a 'POWER RIBBON PAPER ERROR - Door is open' on my DNP DP-DS80D Printer?
- W
  Wendy BakerAug 30, 2025
  If your DNP Printer displays a 'POWER RIBBON PAPER ERROR - Door is open', close the mechanism unit.
M
Michelle BlackSep 2, 2025
What to do if there is a 'POWER RIBBON PAPER ERROR - System error' on my DNP DP-DS80D Printer?
- M
  Mrs. Barbara TorresSep 2, 2025
  If your DNP Printer displays a 'POWER RIBBON PAPER ERROR - System error', restart the printer. If the error persists, it is advisable to call a service representative.
L
Lisa FosterSep 4, 2025
What to do if my DNP DP-DS80D stopped with the paper partially cut?
- K
  karen89Sep 4, 2025
  If your DNP Printer stops with the paper partially cut: 1. Restart the printer, then release the paper and return the cutter blade to its standby position. 2. Remove the partially printed part of the paper from the printer.
T
tayloramandaSep 6, 2025
What to do if the power has been cut during printing on my DNP Printer?
- W
  Wendy BrownSep 6, 2025
  If the power has been cut during printing on your DNP Printer: * Turn the printer on. The partially printed paper will be cut into scrap-size pieces and removed. * Check that no partially printed paper remains in the printer.
W
warrenkellySep 8, 2025
What to do if there is a 'POWER RIBBON PAPER ERROR - No scrap box' on my DNP DP-DS80D Printer?
- A
  Adam DiazSep 9, 2025
  If your DNP Printer displays a 'POWER RIBBON PAPER ERROR - No scrap box', set the scrap box.