12
2.7 Power-Loss Resume
In case of abrupt power failure during printing, the machine will save current printing process and move the functional module
away from the print. You may resume or cancle the process after power recovery.
Resume
Unfinished mission detected ! !
Confirm to continue/cancle/skip?
Description
Continue: Resume the unfinished printing process
Cancle: Cancle the unfinished printing process
“ ”
“ ”
“ ”
Return: The system will prompt you again next time you turn on the machine, provided no file is
executed after the power recovery.Your can use the “Return” button to check and prepare
the machine, such as nozzle preheating and filament replacement.
1. Compared to PLA, soft filament like TPU requires higher printing temperature to reduce feeding resistance, recommended value for
TPU is 210℃~230℃.
1. The filament runout detection must be turned off to preheat the nozzle, and the preheating process will be interrupt if the filament
runout detection is turned on during the process.
2.8 Filament Runout Detection
2.9 Notes for Printing with Soft Filament
The 3D print functional module is designed with build-in filament detection sensor.
3. The filament detection sensor module has adopted modular design. If you do not need the function, or if the sensor is not working,
you can unplug the temperature sensor cable (white) from the module, remove the module connecting cable (black) from the PCB
board on the bottom of plastic cap, and plug the temperature sensor to the PCB board directly. Refer to Section 6.4.4
③ Wait for new filament
to be installed
① Pause and save current
printing process
② Retract the filament residue to
avoid clogging issue, beeper on
④ Continue the
process
2. If the filament runs out during printing, state of the sensor will change from “runout detection turned off” to “runout detection
turned on”, and the filament runout detection function will work as follows:
2. You must reduce extrusion force when printing with soft filament, please refer to step 4 in Section 6.4. Different kinds of soft
filament may vary in required extrusion force. Since extrusion force is proportional to the spring force, inadequate or
intermittentoff feeding issue will occur if the spring force is set too small.On the other hand, if the spring force is set too big, the
filament may curl inside the extruder under high feeding resistance condition. You need to test it according to the soft filament.
3.Recommended heated bed temperature for TPU is 60℃~80℃
To Next Page
Loading...