Dobot MOOZ-2 PLUS - Use the Slicing Software; Install the Slicing Software

6
2.3 Use the Slicing Software
2.3.1 Install the Slicing Software
Description: MOOZ supports most third-party printing softwares, such as Cura, Repetier-Host, etc. Cura 3.1.0 is described here as an example.
Operation steps:
① Double-click to install the software:
② Select the installation directory. It is recommended to keep the
default, click “Next":
③ Select the features you need. It is recommended to keep the defaults,
click "Install":
④ The window of installing arduino driver will pop up in the process of installation. Please follow the prompts to complete the installation.
Cura3.1.0.exe
Cancel
Next >
Browse....
D: \ Program...........................
Cancel
Install
Install....
Install....