Dodge challenger 2016 - Page 153

Reaction Timer
Press the OK button to engage Countdown
Timer. The time it takes for wheel speed not
equal to 0 MPH after the words ’GO’ is your
reaction time. If wheel speed is greater than 0
MPH before ’GO’, the reaction time will be a
negative time.
NOTE:
The Reaction Time, MPH, 1/8 Mile, and 1/4
Mile timers will be “ready” when the vehicle
is at 0 MPH (0 km/h).
1/8 Mile (200 Meters)
When selected, this screen displays the time it
takes the vehicle to travel 1/8 mile within 15
seconds and the vehicle’s speed when it
reaches 1/8 mile.
• The feature will “ready” when the vehicle is at
0 MPH (0 km/h). The word “READY” will flash
when conditions are met for the event to
begin.
• Dashes will display if the vehicle fails to
reach 1/8 mile (200 meters) in less then 15
seconds.
• To clear the vehicle’s best 1/8 mile (200
meters) run, push and hold the OK button for
five seconds.
1/4 Mile (400 Meters)
When selected, this screen displays the time it
takes the vehicle to travel 1/4 mile within 25
seconds and the vehicle’s speed when it
reaches 1/4 mile (400 meters).
• The feature will “ready” when the vehicle is at
0 MPH (0 km/h). The word “READY” will flash
when conditions are met for the event to
begin.
• Dashes will display if the vehicle fails to
reach 1/4 mile (400 meters) in less then 25
seconds.
• To clear the vehicle’s best 1/4 mile (400
meters) run, push and hold the OK button for
two seconds.
Braking Distance
When selected, this screen displays the vehi-
cle’s braking distance, and the speed at which
the brake pedal was pushed.
• This feature will only function when applying
the brakes at speeds above 30 MPH
(48 km/h).
• Engaging the parking brake will disable this
feature.
• The word “READY” will display when condi-
tions are met for the event to begin.
• The distance and speed measurements dis-
play while the event is taking place.
• The distance measurement will be aborted if
the brake pedal is released before the ve-
hicle comes to a complete stop.
• Pushing and holding the OK button will clear
the current and last run values.
Current G-Force
When selected, this screen displays the current
G-Force (lateral and longitudinal) that displays
the directions of the forces.
Peak G-Force
When selected, this screen displays all four
G-Force values (two lateral and two longitudi-
nal).
150