NOTE:
• After pushing the door handle button, you
must wait two seconds before you can
lock or unlock the doors, using either
Passive Entry door handle. This is done
to allow you to check if the vehicle is
locked by pulling the door handle, without
the vehicle reacting and unlocking.
• The Passive Entry system will not operate
if the RKE transmitter battery is dead.
The vehicle doors can also be locked by using
the RKE transmitter lock button or the lock
button located on the vehicle’s interior door
panel.
WINDOWS
Power Windows
The window controls on the driver’s door control
both of the door windows.
There is a single window control on the passen-
ger’s door trim panel that operates the window
on the passenger’s door. The window controls
will operate only when the ignition switch is in
the ON/RUN or ACC position.
NOTE:
• The Key Off Power Delay feature will allow
the power windows to operate for up to 10
minutes after the ignition is turned OFF.
This feature is cancelled when either front
door is opened. The time for this feature
is programmable. Refer to “Uconnect Set-
tings” in “Understanding Your Instrument
Panel” for further information.
• The door window will lower slightly if it is
closed completely when opening the
door. The window will return to its fully
closed position after closing the door.
This action allows the door to open with-
out resistance and prevents window and
seal damage.
WARNING!
Never leave children unattended in a vehicle,
and do not let children play with power
windows. Do not leave the Key Fob in or
near the vehicle, or in a location accessible
to children, and do not leave the ignition of a
vehicle equipped with Keyless Enter-N-Go in
the ACC or ON/RUN mode. Occupants, par-
ticularly unattended children, can become
entrapped by the windows while operating
the power window switches. Such entrap-
ment may result in serious injury or death.
Power Window Switches
25
To Next Page
Loading...
