American Petroleum Institute (API) Engine
Oil Identification Symbol
This symbol
means that the oil
has been certified
by the American
Petroleum Institute
(API). The manu-
facturer only rec-
ommends API
Certified engine
oils.
This symbol certifies 0W-20, 5W-20, 0W-30,
5W-30 and 10W-30 engine oils.
CAUTION!
Do not use chemical flushes in your engine
oil as the chemicals can damage your en-
gine. Such damage is not covered by the
New Vehicle Limited Warranty.
Engine Oil Viscosity — 3.6L Engine
MOPAR SAE 5W-20 engine oil or equivalent
Pennzoil or Shell Helix is recommended for all
operating temperatures. This engine oil im-
proves low temperature starting and vehicle fuel
economy.
The engine oil filler cap also shows the recom-
mended engine oil viscosity for your vehicle.
For information on engine oil filler cap location,
refer to “Engine Compartment” in “Maintaining
Your Vehicle” for further information.
MOPAR SAE 5W-30 engine oil approved to
FCA MS-6395 such as Pennzoil or Shell Helix
may be used when SAE 5W-20 engine oil
meeting MS-6395 is not available.
Engine Oil Viscosity (SAE Grade) — 5.7L
Engine
MOPAR SAE 5W-20 engine oil approved to
FCA Material Standard MS-6395 such as Pen-
nzoil, Shell Helix or equivalent is recommended
for all operating temperatures. This engine oil
improves low temperature starting and vehicle
fuel economy.
The engine oil filler cap also shows the recom-
mended engine oil viscosity for your engine. For
information on engine oil filler cap location, refer
to the “Engine Compartment” illustration in this
section.
NOTE:
Vehicles equipped with a 5.7L engine must
use SAE 5W-20 oil. Failure to do so may
result in improper operation of the Fuel
Saver Technology. Refer to “Fuel Saver
Technology – If Equipped” in “Starting And
Operating” for further information.
Lubricants which do not have both the engine
oil certification mark and the correct SAE vis-
cosity grade number should not be used.
Engine Oil Viscosity — 6.4L Engine
Use Pennzoil Ultra 0W-40 engine or equivalent
MOPAR oil meeting the FCA Material Standard
MS-12633 for use in all operating temperatures.
The engine oil filler cap also shows the recom-
mended engine oil viscosity for your engine. For
information on engine oil filler cap location, refer
to “Engine Compartment” in “Maintaining Your
Vehicle” for further information.
301
To Next Page
Loading...
