DOM ENiQ AccessManager - Operation

ENiQ® Wall Readers & Terminals
_____________________________________________________________________________________
55
Operation
You can use the master card to create programming cards which you can then
use to create closing media.
Please note! The master and programming cards do not function as
closing media.
Master card
The master card has the following functions:
- Initialisation of the DOM devices
- Setting the contact exposure time
- Creation or deletion of individual closing media and programming media
(programming card, software solutions)
- Simultaneous deletion of all closing media and programming media
(programming cards, software solutions)
- Transmission of system parameters via ENiQ
®
AccessManagement software to the
end devices.
Programming card
The programming card has the following functions:
- Creation or deletion of individual closing media
- Deletion of all closing media.
Locking medium (key fob, Clip Tag, card, etc.)
- Locking and opening.
Permanently open card/tag
The permanently open card has the following functions:
- Setting of electronics to permanently open mode
- Resetting of electronics to normal state
- If permanently closed is active, changing to permanently open position.
Permanently closed card/tag
- Setting of electronics to permanently closed mode
- Resetting of electronics to normal state
- If permanently open is active, changing to permanently closed position.