DOM ENiQ AccessManager - Programming; Connecting Voltage Supply; Opening and Locking

ENiQ® Wall Readers & Terminals
_____________________________________________________________________________________
56
Programming
Programming with the master or programming card is always done at the ENiQ
AccessManager®/Terminal/ITT. The signalling to any ENiQ
®
Passive Readers
connected only shows that the controller is busy. After the process has been
completed, the upper LED on the ENiQ
®
Passive Readers is lit red again permanently.
With the ENiQ
®
Module Reader, the status LED goes off and lights up again after the
process has been completed.
Connecting voltage supply
If the red LED on the ENiQ AccessManager® flashes three times and is then
lit red permanently after the voltage supply has been connected, the data/time
are not correct or another fault has been recognised by the firmware.
Opening and locking
To open or lock the door, you must only hold an authorised locking medium a short
distance (1 cm) in front of the DOM devices. These distances can vary depending on
the locking medium.
Please note! If the controller is busy or there is no contact to the
connected ENiQ
®
Passive Readers or an external reader of the ENiQ
®
Module Reader, authorised closing media which are held in front of the
ENiQ
®
Passive Reader or an external reader of the ENiQ
®
Module
Reader are not recognised. In this case, the LEDs on the ENiQ
®
Passive
Readers flash red and violet alternately or the external reader of the
ENiQ
®
Module Reader flashes with its status LED.