Installation Guide YAMORC YD9401 – Upgrade Module
Step 5 - Start up the software
1. Connect your power supply to the DR5000, the power LED should be green.
2. Connect your DR5000’s the computer with the USB cable, the USB LEDs light up
3. On your desktop, click the YD7001 Configuration icon. 3
4. The DR5000 software will now appear on your desktop.
5. If the power supply and USB are OK, the software will show an activation screen
6. Klik in het activatiescherm op de link “Click here to request an Activation Key”
Note: Make sure you have an active connection to the Internet on your computer
1 5
2
6
4
This manual is offered to you by Domburg Train Support in collaboration with Drenth Design & Consulting www.domburgtrainsupport.nl Page 10