Installation Guide YAMORC YD9401 – Upgrade Module
Introduction
Thank you for purchasing the YD9401 upgrade module for your DR5000. Changes your DR5000 panel to a YD7001 Command Station. The YD7001 is the
result of a DR5000 motherboard equipped with a YaMoRC YD9401 upgrade and associated firmware 8.1.x, an upgrade option that you are offered by
YaMoRC.
In this installation guide, we will show you step by step how you can easily perform the upgrade yourself. It is very important that you do not skip a
page and read and run this manual page by page.
Once you have successfully upgraded, you have a full-featured YaMoRC power station! On the YaMoRC and Domburg Train Support website you will find a
manual specially written for the YD7001 Command Station. We hope that with this simple manual, which does not cover all “expert” settings too much, we
can help you to use this multifunctional digital power station!
For support and support you can always visit our helpdesk, or in the user group of YaMoRC!
DTS Helpdesk: https://domburgtrainsupport.nl/helpdesk
User group YaMoRC: www.modelspoorforum.nl
Kind regards,
Domburg Train Support
Disclaimer YD9401 upgrade:
Both DTS and YaMoRC are not responsible for failures of the DR5000 hardware, only on the YD9401 upgrade module and the supplied firmware. Also, the
warranty on the DR5000 at Digikeijs will be canceled as soon as you decide to upgrade.
This manual is offered to you by Domburg Train Support in collaboration with Drenth Design & Consulting www.domburgtrainsupport.nl Page 3
To Next Page
Loading...
Need help?
General
