Domburg DR5000 - Step 11 - Set LAN Settings Correctly

Installation Guide YAMORC YD9401 – Upgrade Module
Step 11 - Set LAN settings correctly
4
1.
To make the LAN settings good, we connect the YD7001 to the LAN input to your
home router through a network cable.
2.
Now open the LAN settings in the software.
3
3. Now check to see if an IP address appears in the Home screen. If not, check the
Internet cable for proper functionality.
4. Verify that the protocol settings match the image.
5. On the Advanced tab, click the host name factory.
6. Now click on the green acceptance button.
5
6
This manual is offered to you by Domburg Train Support in collaboration with Drenth Design & Consulting www.domburgtrainsupport.nl Page 17