Installation Guide YAMORC YD9401 – Upgrade Module
After you have successfully downloaded the software, it is important to first extract the downloaded file and save it to your hard drive.
Then start the installation with a double click on "setup" or "setup.exe".
Make sure that you always have administrator rights on your PC.
Important!
Do not connect the YD7001 to the PC via USB until the software and
driver are successfully installed.
After a few seconds, this screen appears. Click "Next".
If you want to change the location of the software, you can change it on the Next screen. To
change the location, click "Change...". If you do not want to change the location, leave the
settings unchanged and click "Next".
This manual is offered to you by Domburg Train Support in collaboration with Drenth Design & Consulting www.domburgtrainsupport.nl Page 8
To Next Page
Loading...
Need help?
General
