Operation CoolFreeze
12
6Operation
6.1 Before initial use
I
The handles are enclosed unassembled. If you wish to attach the handles, proceed
as follows:
➤ Make a handle by putting two holders (fig. 4 1, page 4) and a handle (fig. 4 2,
page 4) together.
➤ Fasten the grip with the enclosed screws in the holes provided.
Selecting the temperature units
You can switch the temperature display between Celsius and Fahrenheit. This is how
to do it:
➤ Switch on the cooler.
➤ Press the “SET” button (fig. 2 4, page 3) twice.
➤ Use the “UP +” (fig. 2 6, page 3) and “DOWN -” (fig. 2 7, page 3) buttons to
select Celsius or Fahrenheit.
✓ The selected temperature units then appear in the display for a few seconds. The
display flashes several times before it returns to the current temperature.
Turning the lid stop around
You can turn the lid stop around if you want to open the lid from the other side.
To do this, proceed as follows:
➤ Undo the screws on the lock lugs (fig. 5 1, page 4) and take them off.
➤ Undo the screws on the hinges (fig. 5 2, page 4) and take them off.
➤ Lay the lid down.
➤ Fit the hinges on the side you want.
➤ Fit the lock lugs on the side you want.
NOTE
Before starting your new cooler for the first time, you should clean it
inside and outside with a damp cloth for hygienic reasons (please also
refer to the chapter “Cleaning and maintenance” on page 19).
CF80_CF110-O-US.book Seite 12 Mittwoch, 10. Mai 2017 6:22 18
To Next Page
Loading...
Need help?
General