Operation CoolFreeze
16
6.5 Using the cooler
A
➤ Place the cooler on a firm foundation.
Make sure that the ventilation slots are not covered and that the heated air can
dissipate.
➤ Close the cooler, see chapter “Connecting the cooler” on page 13.
I
A
➤ Press the “ON/OFF” button (fig. 2 1, page 3) for between one and two
seconds.
✓ The “POWER” LED lights up.
✓ The display (fig. 2 5, page 3) switches on and shows the current cooling
temperature.
I
✓ The cooler starts cooling the interior.
I
NOTICE! Danger of overheating!
Ensure at all times that there is sufficient ventilation so that the heat that
generated during operation can dissipate. Ensure that the ventilation
slots are not covered. Make sure that the device is sufficiently far away
from walls and other objects so that the air can circulate.
NOTE
If you wish to operate the cooler from the AC mains, set the battery
monitor to the “LOW” position.
NOTICE! Danger from excessively low temperature!
Ensure that the only those objects are placed in the cooler that are
intended to be cooled at the selected temperature.
NOTE
The temperature displayed is that of the middle of the interior.
The temperatures elsewhere can deviate from this temperature.
NOTE
When operating with the battery, the display switches off automatically
if the battery voltage is low. The LED “POWER” flashes orange.
CF80_CF110-O-US.book Seite 16 Mittwoch, 10. Mai 2017 6:22 18
To Next Page
Loading...
