Operation CoolFreeze
18
6.9 Replacing the device fuse
!
➤ Pull off the connection cable.
➤ Pry out the fuse insert (fig. 3 2, page 3) with a screwdriver.
➤ Replace the defective fuse with a new one that has the same rating (T2.5AL250V).
➤ Press the fuse insert back into the housing.
6.10 Replacing the light bulb
➤ Press the switch pin (fig. 8 2, page 5) downwards so that the transparent part
(fig. 8 1, page 5) of the lamp can be removed at the front.
➤ Replace the light bulb.
I
➤ Press the transparent part of the lamp back into the housing.
WARNING! Danger of electrocution!
Disconnect the connection cable before you replace the device fuse.
NOTE
The LEDs in the light bulb must be aligned with the transparent part of
the lamp.
CF80_CF110-O-US.book Seite 18 Mittwoch, 10. Mai 2017 6:22 18
To Next Page
Loading...
