Operation CoolFreeze
14
A
➤ Before starting up the device for the first time, check whether the operating
voltage and the battery voltage correspond (see type plate).
➤ Make sure that the cable at the positive battery terminal (fig. 7 2, page 5) is
protected with a 15 A fuse (fig. 7 3, page 5).
➤ Plug the 12/24-V connection cable (fig. 1 2, page 3) into the DC socket on the
cooler (fig. 7 1, page 5).
➤ Connect the red cable (fig. 7 rt, page 5) to the positive terminal of the battery
(fig. 7 2, page 5).
➤ Connect the black cable (fig. 7 sw, page 5) to the negative terminal of the
battery (fig. 7 2, page 5).
Connecting to a 100 – 240 V AC mains (E.g. in the home or office)
D
The cooler has a built-in multi-voltage mains adapter with a priority circuit for con-
necting to a 100 – 240 V
~ supply. The priority circuit automatically switched to mains
operation if the appliance is connected to a 100 – 240 V
~ supply, even if the 12/24 V
cable is still connected.
When switching between the AC mains and the battery supply, the red LED may
light up briefly.
➤ Plug the 100–240 V connection cable (fig. 1 3, page 3) into the AC voltage
socket and connect it to the 100 – 240 V AC mains.
NOTICE! Danger of damaging the device!
Make sure that the polarity is correct.
DANGER! Danger of electrocution!
• Never handle plugs and switches with wet hands or if you are
standing on a wet surface.
• If you are operating your cooler on board a boat from a mains
connection of 100 – 240 V
~, you must install a residual current circuit
breaker between the 100 – 240 V AC mains and the cooler.
Seek advice from a trained technician.
CF80_CF110-O-US.book Seite 14 Mittwoch, 10. Mai 2017 6:22 18
To Next Page
Loading...
