EnviroComfort Installation Manual Review the Installation Checklist
L-2657 ENGLISH 15
8. Avoid loops, high spots or the use of 90-degree elbows with seawater hose. Each 90-degree elbow is equivalent in
pressure drop to 2.5 feet (76.2cm) of hose and a 90-degree elbow on the pump outlet is equivalent to 20 feet
(609.6cm) of hose.
9. Double-clamp all hose connections with stainless-steel clamps, reversing the clamps.
10. Use teflon tape (2 to 3 wraps only) on all threaded connections. Tighten one and a half turns beyond hand tight. Do not
over-tighten!
11. Connect all metallic parts in contact with seawater to the vessel’s bonding system, including the speed scoop inlet,
strainer, pump and the air conditioner.
Figure 8: Seawater Pump & Plumbing Diagrams
REVIEW THE INSTALLATION CHECKLIST
Return to “Installation Checklist” on page 3 and make sure you have completed all the steps.
NOTE
Over-tightening can create eventual cracks within hours or days. Be sure to check for leaks before commissioning the
boat. If you are unsure about this procedure, ask a qualified marine technician to avoid sinking your boat.
To Next Page
Loading...
Need help?
General
