Unpacking and Inspection EnviroComfort Installation Manual
2 L-2657 ENGLISH
KIT CONTENTS
EnviroComfort is a complete marine air conditioning kit that includes everything needed for a professional installation. Each kit
includes:
• Air conditioning unit with electrical box
• Dometic Digital Display temperature-control device
• Ducting
• Supply-air grille
• Return-air grille
• Seawater pump
• Strainer
• Speed scoop thru-hull
• Overboard fitting
• Seawater hose
• Fittings for pump and strainer
TOOLS REQUIRED FOR INSTALLATION
• Screwdrivers - both types
• Pliers
• Pipe wrench
• Wire cutters/crimpers
• Drill & 7/8" bit
• Power screwdriver
• Jig saw
• Hull saw
•Duct tape
• Electrical tape
• Teflon tape
• Marine-grade waterproof (below waterline) bedding compound to seal thru-hull fittings
• Hardware to secure unit, pump, strainer, grilles, electrical box and control panel
UNPACKING AND INSPECTION
Before attempting to install your new air conditioning system, you must read this installation manual completely.
Failure to perform certain tasks in the proper sequence could result in an inoperative system as well as a voided warranty.
If, upon opening your new system, you discover any parts are missing, contact your dealer immediately. Check all items
carefully against the packing list to ensure all cartons have been received. Move units in the normal “up” orientation as indicated
by the arrows on each carton. Examine cartons for shipping damage, removing the units from the cartons if necessary. If the unit
is damaged, the carrier should make the proper notation on the delivery receipt acknowledging the damage.
To Next Page
Loading...
Need help?
General
