BASIC OPERATIONS
77144 Issue 8 August 2009 47
Powering Up
When the unit is correctly connected, the power can be switched on.
WARNING: If the printer is being run for the first time since
installation or re-mounting, the air flow vents must
be released - see page 37.
Note: If connecting for the first time, it may take a few minutes for the ink to transfer
from the bottle into the chamber.
(1) To power on the printer, press the power
switch on the bottom/top right side of the
unit (as shown). This switch will illuminate
to indicate that power is on.
Power
Switch
Power
Switch
2 Litre Base
200ml Base
To Next Page
Loading...
Need help?
General
