Domino G20I Guide

(24) EPT052026 Issue 1 February 2019
Set print direction ^1V01CS*x\0 *x=0: Left to right normal.
*x=1: Right to left normal.
*x=2: Left to right inverted
*x=3: Right to left inverted
^1V01CS0\0 = Left to right
normal.
^1V01CS1\0 = Right to left
normal.
^1V01CS2\0 = Left to right
inverted.
^1V01CS3\0 = Left to right
inverted.
Set print mode ^1W01CS*x*y*z
*t\0
*x=0: Sensor mode.
*x=1: Continuous mode.
*y: Number of prints for each
time the sensor is triggered
(mandatory 3 characters).
This value is passed if using
continuous mode.
*z: Space between prints, in
inches (mandatory 5
characters).
*t:=0 Continuously print after
the product detect sensor is
triggered once.
*t:=1 continuously print when
the product detect sensor is
continuously triggered. Stop
printing when the product
detect sensor is not
triggered.
^1W01CS0002003930\0 = Print
in sensor mode. Make 2 prints,
each time the sensor is
triggered. Set a 10cm space
between prints. Continuously
print after the product detect
sensor is triggered once.
Set print delay
time
^1D01CS*x*y\0 *x= Delay before print, in
inches. Range = 00039-
39370 (mandatory 5
characters).
*y= Delay after print, in
inches. Range = 00039-
39370 (mandatory 5
characters).
^1D01CS0019600393\0 = Set a
delay of 5cm before the print
and 10cm after the print.
Set sensor ^1H01CS*x\0 *x=0: Use internal product
detect sensor.
*x=1: Use external product
detect sensor.
^1H01CS0\0 = Use the internal
product detect sensor.
^1H01CS1\0 = Use an external
product detect sensor.
Table 2: PLC to Printer
Operation Command Parameter Examples

Domino G20I Specifications

General

Brand	Domino
Model	G20I
Category	Printer
Language	English