Domino G20I Guide

EPT052026 Issue 1 February 2019 (33)
Dynamic barcode
setup
^1h01CS*x*y*z*
a*b*c*d*e*f*g##*
f\0
*x: Set the barcode type.
0=Code39, 1=Code2of5,
2=Code128, 3=Code93,
4=CodeUPC-A,
5=CodeEAN, 6=CodaBar,
7=Code11.
*y: Set the barcode width,
range 1-4.
*z: Set the barcode height,
range 1-3.
*w=0: Disable human
readable text.
*w=1: Enable human
readable text.
*a=0: Count upwards.
*a=1: Count downwards.
*b=1: Fill zeros (always = 1).
*c: Counter steps. Range =
000-250 (mandatory 3
characters).
*d: Counter start value.
Range = 0000000001-
2000000000 (mandatory 10
characters).
*e: Current counter value.
Range = 0000000001-
2000000000 (mandatory 10
characters).
*f: Counter reset value.
Range = 0000000001-
2000000000 (mandatory 10
characters).
*g: Prefix of barcode,
maximum 10 characters.
*f: Suffix of barcode,
maximum 10 characters.
1h01CS0131010020000000000
00000000020000010000AB##\
0
=
Set barcode type as Code39.
Set barcode width to 1.
Set barcode height to 3.
Enable human readable text.
Count upwards.
Fill zeros.
Count in steps of 2.
Counter start value:
0000000000.
Current counter value:
0000000002.
Counter reset value:
0000010000.
Prefix: AB.
No suffix.
Table 2: PLC to Printer
Operation Command Parameter Examples

Domino G20I Specifications

General

Brand	Domino
Model	G20I
Category	Printer
Language	English