3.2.2 Tools required to change and disassembling the steering handle base order
●Use appropriate support to support the car, so that the front wheel will hang in the air.
●Dismantle the parts in order. While installing, follow the sequence in an opposite
direction of the dismantling process.
●If the solid wrench is not applicable, you can switch to sleeve or speed wrench of the
same specification.
3.2.3 Change the steering handle base
① Place iTank on a flat platform ②Dismantling steps:
●Lower part of the front panel
●Front storage box trimming : Clutch on one end of the front storage box trimming, pull it
down with great force.
●Front storage box left trimming: After twisting the screw, Clutch on one end of left trimming
of the front storage box, pull it down with great force.
To Next Page
Loading...