Notes:
⚫ Use appropriate support to support the car, so that the front wheel will hang in the
air.
⚫ Dismantle the parts in order. While installing, follow the sequence in an opposite
direction of the dismantling
⚫ If the solid wrench is not applicable, you can switch to sleeve or speed wrench of
the same specification.
3.6.3 Disassemble and switch the front mechanism (the whole machine)
① Put the iTank on a flat platform, then use appropriate support to support the iTank
to make the front wheel be above the ground, and do not let it overset.
②Dismantling steps:
● Lower part of the front panel
● Trimming of front storage compartment
To Next Page
Loading...