● Rubber sleeve seal cartridge cut off the ribbon that binds the bearing rubber case
● Steering linkage assembly Pull the bearing dust prevention rubber case on in the
circle of the picture below to the inside to display the knuckle bearing at the end of
the rod, Then take off the left steering base, connecting rod of the steering column
and the cotter of the right steering base separately, and use a 16# wrench to unscrew
the three M10 open slot nuts, take out the steering linkage assembly and use a 16#
wrench to unscrew the three M10 open slot nuts, take out the steering linkage
assembly
Steering linkage assembly
③ Change the steering linkage assembly in the opposite order of disassembly
3.6.6 Disassembly and change the steering base
To Next Page
Loading...
