Notes:
● The steering base is divided into left steering base and right steering base, if you
want to change the left steering base, you only need to disassemble the parts connected
to the left steering base, and the same for switching right steering base.
① Put the iTank on a flat platform, then use appropriate support to support the iTank
to make the front wheel be above the ground, and do not let it overset.
② Dismantling and switch procedure:
●Lower part of the front panel
●Rubber sleeve's seal cover
●Steering linkage assembly: take off the rod end knuckle bearing at the side of the
steering base that needs to be switched
Refer to "Disassemble and switch steering linkage assembly"
●Steering base: unscrew the 3 bolts in the circle of the picture below
To Next Page
Loading...
