Chapter 2 Standard component specification and general torque
This chapter is used to inform the customers the specification of the standard
components the vehicle uses and their corresponding repair tools.
Specify the locking torque force for standard fixtures according to ISO standard screw
thread depth. The manual has already explained the locking torque force of the special
components or assembly in relevant chapters. In order to prevent curling, please lock
the multi-fixture assembly to designated torque force in cross mode and progressive
manner. Unless otherwise prescribed, the locking torque should be based on clear and
dry screw thread; the components should maintain the room temperature standards.
1、The car uses hexagon flange bolt, whose national standard number is GB/T 5789-
2000. For the standard component specification, repair tools specification and general
torque please refer to the following table:
To Next Page
Loading...