GENERAL SAFETY INSTRUCTIONS FOR INSTALLATION AND MAINTENANCE
• For an efficient and safe automated door, correctly observe the installation procedures and instructions for use.
• Incorrect installation and use can cause serious damage to persons and property.
• Carefully read the whole installation manual before you begin installing.
• Do not make any modifications which are not mentioned in this manual.
• Do not install the operator for uses other than those indicated.
• To fasten, use the supplied accessories or, in any case, fastening systems (screws, expansion plugs, etc.) suitable for the type of support
and for the mechanical stresses exerted by the automated system.
• Check if the gate conforms to standards EN12604 and EN 12605 (the information can be found in the documentation accompanying the
gate itself). For non-EU countries, the above mentioned standards must be observed in addition to the national standard references to
obtain a suitable safety level.
• Make sure that the gate is correctly operational, and supplied with mechanical opening stops.
When installing we advise you to:
• obtain the material and tools indicated in the following paragraph “Tools and materials” and keep them near at hand.
• use a stable support for performing operations without a floor support.
• protect your face and hands adequately before making the holes with the drill.
• do not allow children to play near during installation, use and during the automated system release manoeuvre.
• remove any debris and objects which could hamper movement, before powering up the system.
• remove the gate’s closing mechanism to ensure the gate is closed by the automatism.
• stick on the warning stickers as shown in the instruction.
When you have finished installing we advise you to:
• Make sure that no part of the gate interferes with public spaces such as pavements and/or roads.
• Use the automated system observing the instructions in the “User’s guide”.
• Fill in, keep and update the maintenance register.
• The SWING automated system does not require periodic replacement of parts.
• Every month, run a functional check of the safety devices.
To Next Page
Loading...
General